For the tri-state codeword above – 011000001000 - the address is 01100000 (channel 5) and the data/command is 1000 (turn on). The LX2262A-R4 uses a 12 tri-state bit codeword comprising 8 address bits followed by 4 data bits. The Arduino should decode the signal and print the results in the serial monitor. Hold your remote near your receiver module and press a button. Open the rc-switch “ReceiveDemo_Advanced” example sketch. Rc-switch has built-in functions that sends codewords for certain natively supported devices – so If you have one of these devices (I don’t) you may be able to skip this step.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |